VESTAKEEP® - Additional Information

VESTAKEEP® PEEK outperforms metals by improving system durability and reducing component manufacturing cost. These benefits are derived from a superior combination of corrosion resistance, abrasion resistance, strength-to-weight attributes, and processing versatility. Use of PEEK eliminates corrosion due to salts, solvents, caustics, and many acids and also reduces abrasive wear due to slurries, particulate impact, and moving surfaces. These properties have allowed PEEK to outperform aluminum, titanium, and steel in air impellers in aircraft, in bushings in mining, pulp, and paper industries. Pound-for-pound, PEEK has a higher strength-to-weight ratio than steel. Lower mass parts provide fuel savings in transport, improved durability in compressor components, and more efficient motor design for gears and impellers. Replacing metals with VESTAKEEP® PEEK reduces component cost due to improved durability, efficient processing methods, part consolidation, and increased design freedom over machined metals.

Compared to other plastics, PEEK provides the best combination of inertness and heat resistance. PEEK retains original properties after long-term exposure to steam, ethylenoxide, and gamma radiation. Low extractables, outgassing, and contaminates make PEEK an excellent material for wafer handling in semiconductor manufacturing processes. PEEK has excellent oxidative stability in the melt and can be used continuously at temperatures exceeding 220°C/430°F (dynamic stressed 180°C/360°F).

Evonik provides VESTAKEEP® PEEK resins in fine powders for composites, compression molding, and coatings; pellets for compounding; and granules for injection molding and extrusion. In addition to unfilled products; reinforced grades are available to improve cyclic fatigue performance, modulus, and abrasion resistance; and tribological grades are available to reduce friction and wear.

Here you get back to our homepage: VESTAKEEP®